Let the wind blow!

Let the Wind Blow!

In the past humans have been using wind energy to navigate the seas and rivers. Nowadays windmills are used to generate electricity to supplement the existing regional power grids.

Humans have been using wind energy to navigate the seas and rivers since the ancient Egyptians. Not quite as early, but equally impressive, the first beginnings of using wind energy on dry land can be dated back to the simple wooden windmills used in the Arab region more than 2000 years ago. Today, windmills are giant computer-controlled machines made of high-tech materials. Instead of grinding grains and moving water, they are spread all over the world to generate electricity to supplement the existing regional power grids. By the end of 2019, wind turbines with a nominal capacity of just over 651 gigawatts were installed and delivering energy worldwide. And the trend today is only going upwards as more and more offshore and onshore wind farms are built.

In some instances, the new generation of wind turbines are much higher than New York's Statue of Liberty, with rotor blades larger than the wingspan of an Airbus A380 aircraft. And that's not all: the development of even larger ones is in progress. As these huge blades have to withstand extreme wind and weather for more than 20 years with very little maintenance, there are many challenges in manufacturing high-performance rotor blades.

With the development of even larger rotor blades the demands on the manufacturing side for the bonding processes is also changing as increasing bond line lengths require adhesive systems with extended gel times. To address this topic and to meet upcoming challenges in wind turbine blade production, Evonik's Crosslinkers business line has enhanced its established ANCAMIDE® 3030 curing agent by extending its gel time from around 110 minutes to more than 250 minutes with the development of the new grade. Besides their differences in gel time and viscosity, both curing agents offer a similar level of mechanical properties and thermal resistance after curing with standard epoxy resins at 70°C for 5 hours. With its series of ANCAMIDE® 3030 curing agents and its derivatives Evonik provides a versatile and easy-to-integrate tool-box enabling formulators to cope with upcoming challenges in wind turbine blade production.

Evonik Crosslinkers – Creating Bonds That Last

Evonik Crosslinkers combines expertise in isophorone chemistry and epoxy curing agent technology to support customers worldwide in coatings, adhesives, civil engineering, high-performance elastomers, and composites.

Our comprehensive toolbox of amine-based curing agents, modifiers, diluents, and resins for ambient and heat-cure systems helps enhance the performance, durability, and processing efficiency of epoxy formulations.

Creating bonds that last, both in materials and in customer relationships, is the principle that guides our innovation, production, and technical support.

With its series of the ANCAMIDE® 3030 curing agent and its derivates Evonik provides a versatile and easy-to-integrate tool-box enabling formulators to cope with upcoming challenges in wind turbine blade production.